Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Radio Removal Tool: T10057
- Fiber-Optic Repair Set - Connector Protective Caps: VAS6223/9 .
The Information Electronics Control Module 1 -J794- is located in the glove compartment.
NOTE:
If replacing the control module, select the "Replace control module" function for the corresponding control module on the Vehicle Diagnostic Tester.
-- Turn off the ignition and all electrical equipment and remove the ignition key.