Secondary Air Injection Solenoid Valve -N112-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Loosen the hose clamp -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and push the left air duct pipe slightly to the left.

-- Disconnect the connector -1-.

Fig 1: Secondary Air Injection Sensor 1 -G609-, Secondary Air Injection Solenoid Valve -N112- Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connecting pipe -2- to do so push the locking ring on both sides together.

-- Remove the bolts -arrows- and remove the secondary air injection solenoid valve -3-.