Exhaust Gas Temperature Sensor, Removing And Installing, AWD Vehicles: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.
-- Bring the pre-particulate filter temperature sensor into its installation position:
- Angle -α- = maximum 15°.
-- Bring the angled post-particulate filter temperature sensor (on some versions) into its installation position:
- Angle -α- = maximum 15°.
There are additional procedures depending on the model. Refer to EXHAUST TEMPERATURE REGULATION .