Timing Chain Cover, Removing And Installing, Engine With One Camshaft Adjuster: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

Replace the gasket and O-ring after removal.

-- Coat the seal and the O-ring with engine oil.

Seal installation position: smaller inner diameter points outward.

-- Install the Camshaft Adjustment Valve 1 -N205-. Refer to Camshaft Adjustment Valve 1 -N205-, REMOVING AND INSTALLING .

Additional procedures depending on the model. Refer to TIMING CHAIN COVER, REMOVING AND INSTALLING .