Ribbed Belt, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Depending on the model, preliminary work may be required. Refer to RIBBED BELT, REMOVING AND INSTALLING .

Depending on the model: Audi S3 and SQ3 vehicles:

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

Continuation for All Vehicles:

CAUTION:

Risk of destroying a used ribbed belt by reversing the running direction.

- Mark the running direction before removal.

- Pay attention to the running direction when reinstalling.

-- Mark the running direction using chalk or a felt-tip pen.

-- Turn the tensioner in direction of -arrow- to release the tension on the ribbed belt.

Fig 1: Ribbed Belt For Vehicles With Electro-Mechanical Power Steering

Courtesy of AUDI OF AMERICA, LLC

-- Secure the tensioner using the : T10060A .

-- Remove the ribbed belt.