LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Engine Assembly [CNTC,CYFB] (1 Of 2) [Coupe]) >> 10 Engine Assembly >> SUBFRAME Mount >> Transmission Mount, Removing And Installing >> Removing

Transmission Mount, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Variation: release the catch in direction of -arrow- and push the bleeder -1- upward.

GWWA10-11916Courtesy of AUDI OF AMERICA, LLC

-- Free up the wires -2- on the air filter housing bracket -1- using the :80-200  .

GWWA24-10922Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the bracket.

-- Remove the Engine Control Module -J623- from the bracket. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and remove the bracket -1-.

GWWA34-11052Courtesy of AUDI OF AMERICA, LLC
NOTE:

Depending on the version different brackets are installed.

-- Unclip the wiring guide -1- upward in direction of -arrows- and move it slightly to the side.

Fig 1: Identifying Wiring Guide
GWWA34-10923Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the transmission mount -1-.

Fig 2: Identifying Bolts And Transmission Mount
GWWA34-11054Courtesy of AUDI OF AMERICA, LLC