Repair Kit For FLEXRAY Wires Without Coating
WARNING: This page is about a different variant/trim than selected.
NOTE:
Observe general notes for repairs on the vehicle electrical system. Refer to VEHICLE ELECTRICAL SYSTEM, GENERAL REPAIR INFORMATION .
The repair of FlexRay wires without coating can only take place using FlexRay wires without coating from the Parts Information.
Unshielded, twisted two-wire lines -1 and 2- with a cross section of 0.35 mm 2 can be used as FlexRay wires.
- During repair work, both FlexRay wires must have the same length.
- When twisting the wires -1 and 2- together, the -A- = 20 mm routing length must be maintained.
- While doing so, no section of wire may be greater than -B- = 40 mm without twisting the wires, for example in the area of crimp connectors -arrow-.
- Mark the location of the repair with something suitable, for example, with yellow tape.
- Repairing both FlexRay wires is identical to repairing just one wire.
- Position both repaired locations -A- = 20 mm opposite each other.
- Crimp the cables with connectors.
1 - Repair location in wiring harness
2 - Repair location with connectors