Front Three-Point Seat Belt, Removing And Installing, TT Coupe: Installing
- Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS FOR PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker pin, for example.
Install in reverse order of removal and note the following:
-- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.
Make sure the connectors are installed all the way and engage audibly.
After replacing the Left and Right Front Seat Belt Tensioner Control Module -J854- / -J855- the control module must be coded using the Vehicle Diagnostic Tester.
-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount in direction of -arrow- and tighten the bolt.
-- Attach the connector -1- to the igniter in direction of -arrow A-.
-- Push in the connector lock -2- in direction of -arrow B-. While doing so, the connector is pushed all the way into the igniter and locks into place at the same time.
The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
Repairing pyrotechnic components (for example the airbag and seat belt tensioner) incorrectly increases the risk of injuries due to unintentional deployments when the ignition is switched on.
- If the ignition is not switched on after the battery is reconnected - >>indicator lamps in the instrument cluster do not light up<< - the ignition (key/button) may only be switched on when the driver seat is positioned all the way back.