LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Passenger Protection, Airbags, Seat Belts [Coupe]) >> 69 Passenger Protection, Airbags, Seat Belts >> Passenger Occupant Detection System >> Passenger Occupant Detection System, Removing And Installing >> Installing

Passenger Occupant Detection System, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.
WARNING:

Risk of injury due to involuntary deployment.

  • Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS FOR PYROTECHNIC COMPONENTS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
  • Follow the instructions when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

Install in reverse order of removal and note the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.

When installing a new service kit, apply the basic setting for the passenger occupant detection system control module. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .

-- Select the "Airbag" function in "Guided Fault Finding"  using the Vehicle Diagnostic Tester to complete.

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals