Airbag Connector, Replacing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Release Connector Lock Using A Small Screwdriver & Disconnect Harness Connector

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS FOR PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker pin, for example.

-- Connect the connector -1- to the airbag igniter in direction of -arrow A-.

-- Press in the connector lock -2- in direction of -arrow B-. While doing this, the connector is pushed into the airbag igniter and locks into place.

Installation is performed in reverse order of removal, while noting the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.