LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Passenger Protection, Airbags, Seat Belts [Coupe]) >> 69 Passenger Protection, Airbags, Seat Belts >> Belt Fastening Detection >> Front Passenger Occupant Detection Sensor -G128-, REMOVING AND INSTALLING >> Installing

Front Passenger Occupant Detection Sensor -G128-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.
CAUTION:

The new passenger occupant detection sensor should be installed in the same location as the old sensor.

Install in reverse order of removal and note the following:

-- Push the clips for the passenger occupant detection sensor into the seat pan until they click into place.

NOTE:

Make sure the connectors are installed all the way and engage audibly.

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals