Wheel Housing Liner Retaining Strip, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- The vehicle and the retaining strip must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution :D 009 401 04 and let dry.
-- Remove the protective film from the adhesive tape.
-- Place the retaining strip, secure using expanding rivets and press on along the entire length.
- Vehicle resting time is at least 30 minutes at room temperature.