Side Reinforcement Brace, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the molded foam part. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
-- Remove the pressure hose sensor for front pedestrian protection -1- and free up the pressure hose -5-. Refer to Pedestrian Protection .
-- Disconnect the connector and free up the wiring harness -3-.
-- Remove the bolts -4-.
-- Release the catches -arrows-.
-- Disconnect the washer fluid hose from the headlamp washer system spray nozzle.
-- Remove the reinforcement brace -2- to the rear.