LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Exterior Equipment [Coupe]) >> 66 Exterior Equipment >> Spoiler >> Spoiler, Removing And Installing >> Fixed Spoiler, Removing And Installing >> Removing

Fixed Spoiler, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Coupe: remove the drip rail. Refer to DRIP RAIL, REMOVING AND INSTALLING .

-- Lift the cover for the spoiler -1- using the : T10383/1  in the direction of the -arrow-.

GWWA66-11885Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

GWWA66-12133Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear lid lower trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the water drain hose -1- from the mount -2- for the water drain.

GWWA66-12006Courtesy of AUDI OF AMERICA, LLC

Roadster: 

GWWA55-11190Courtesy of AUDI OF AMERICA, LLC

-- Pull the release cable -5- to the right in direction of -arrow- and open the coupling cover -6- at the same time the release cable nipple is disengaged.

-- Free up the coupling catch on the mount -4- and disengage to the left at the same time.

-- Move the release cable -1- to the side.

Continuation: 

GWWA66-11887Courtesy of AUDI OF AMERICA, LLC

-- Release the catches -1 and 3-.

-- Guide the left and right anti-theft protection -4- out of the opening -arrow- at the same time free up the wiring harness -2-.

-- Remove the nuts -1 to 13-.

GWWA66-11467Courtesy of AUDI OF AMERICA, LLC

-- Remove the spoiler from the rear lid and lay it down on a soft surface.