Overview - Electric Spoiler
WARNING: This page is about a different variant/trim than selected.
- Nut
- Tightening specification and sequence. Refer to Fig 2.
- Replace after removing.
- Quantity: 13
- Mount with Drive Unit
- For the spoiler
- With seal
- Replace the mount if the seal is damaged
- Removing and Installing. Refer to MOUNT WITH SPOILER DRIVE UNIT, REMOVING AND INSTALLING .
- Foam Seal
- Replace after removing.
- Self-adhesive
- Bonding Point
- For the 10 mm diameter hole
- Apply on the inside on the spoiler
- Quantity: 4
- Plug
- For the 30 mm diameter hole
- Insert on the inside in the spoiler
- Quantity: 2
- Buffer
- Replace after removing.
- Center
- The vehicle and buffer must be at room temperature.
- Clean the adhesive surface on the spoiler with Cleaning Solution: D 009 401 04 and let it dry.
- Place on the marking and press firmly
- Spoiler
- Removing and Installing. Refer to ELECTRIC SPOILER, REMOVING AND INSTALLING .
- Buffer
- Replace after removing.
- Side
- Quantity: 2
- The vehicle and buffer must be at room temperature.
- Clean the adhesive surface on the spoiler with Cleaning Solution: D 009 401 04 and let it dry.
- Place on the marking and press firmly
- Adjusting Mechanism
- Equipped with a new seal -item ) Foam Seal clipped in the spoiler
- Adjusting. Refer to SPOILER, ADJUSTING .
- Buffer
- Replace after removing.
- Inserted in the rear lid
- Removing and Installing. Refer to BUFFER, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Replace after removing.
- Quantity: 2
- Adjusting. Refer to SPOILER, ADJUSTING .
- Water Drain Hose
- When attaching on the mount -item 2- pay attention to the marks.
- Mount
- For the water drain
Spoiler - Tightening Specification and Sequence
-- Tighten the nuts to 2 Nm in the following sequence: -1 through 13-.