Buffer, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• The vehicle and the buffer must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04  and let dry.

-- Check the seal -2- for damage.

Courtesy of AUDI OF AMERICA, LLC

• Make sure that the foam seal is sitting on the clip.

-- Slowly remove the protective film -3- from the adhesive tape.

-- Position the buffer -1- and press the clips on until they engage audibly.