General Information - Name Badges And Emblems, Replacing: Installing
WARNING: This page is about a different variant/trim than selected.
- Loosened name badges and emblems must be replaced.
- The vehicle as well as the name badges and emblems must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- After successfully assembling, press on the emblems again with the roller.
- Vehicle resting time is at least 30 minutes at room temperature.