LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Exterior Equipment [Coupe]) >> 66 Exterior Equipment >> Moldings, Trims, Extensions And Trim Panels >> Trim Molding, Removing And Installing >> Trim Molding, Removing And Installing, A-Pillars >> Removing

Trim Molding, Removing And Installing, A-Pillars: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the inner door seal/windshield frame seal in the A-pillar area. Refer to INNER DOOR SEAL/WINDSHIELD FRAME SEAL, REMOVING AND INSTALLING .

-- Drill out the rivet heads -2- from the pop rivets and drive out the rivet shafts.

GWWA66-11449Courtesy of AUDI OF AMERICA, LLC

-- Remove the trim molding -1-.

scientia non olet · About LEMON Manuals