LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Heating, Ventilation [Coupe]) >> 80 Heating, Ventilation >> Overview - Heater >> Heater >> Climatronic Control Module -J255-, REMOVING AND INSTALLING

Climatronic Control Module -J255-, REMOVING AND INSTALLING

WARNING: This page is about a different variant/trim than selected.

The removal and installation is identical to a vehicle with an A/C system. Refer to Climatronic Control Module -J255-, REMOVING AND INSTALLING .

NOTE:

There are different versions of the Climatronic Control Module -J255- -B- and various display control heads for vehicles without an A/C system, with a manual or an automatic climate control system. Refer to OVERVIEW - DISPLAY CONTROL HEAD . Make sure the various display control heads (Front A/C Display Control Head 2 -E775- through Front A/C Display Control Head 4:E777  ) are correctly allocated to each other and to the Climatronic Control Module -J255- -B-. Interchanging components for vehicles without an A/C system, with a manual or with an automatic climate control system is not permitted.

GWWA87-11649Courtesy of AUDI OF AMERICA, LLC

The Climatronic Control Module -J255- -B- is installed on the left of the instrument panel crossmember on right-hand drive vehicles.

NOTE:

To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function. Refer to appropriate service information.