General Information

WARNING: This page is about a different variant/trim than selected.

NOTE:

Connect the A/C service station. Refer to A/C SERVICE STATION, CONNECTING .

Observe the test requirements. Refer to PRESSURES, CHECKING .

-- With the ignition switched off, check the pressure in the refrigerant circuit (using the service station). Refer to REFRIGERANT CIRCUIT, CHECKING PRESSURE WITH SERVICE STATION .

The pressures with the ignition turned off meet the specifications.

-- Start the engine.

-- Bring the engine speed up to 2000 RPM.

-- Observe the pressure gauge of the service station.

NOTE:

The switch pressures and design of refrigerant circuit switches are vehicle-specific.

Pressures must be measured at service connections; component locations of these connections are vehicle-specific. Refer to Refrigerant Circuit (vehicle-specific Service Information).