LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Wiring [Coupe]) >> 97 Wiring >> Control Modules >> Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING >> Removing

Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.
GWWA97-11879Courtesy of AUDI OF AMERICA, LLC

-- Remove the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Remove the A-pillar lower trim panel. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Disconnect the connectors -1, 2 and 3-.

-- To disconnect the connector, press the tab -1-, turn the retaining bracket in direction of -arrow- and remove the connector.

Fig 1: Pressing Catch -1-, Turn Retaining Bracket In - Direction Of Arrow For Removal
GWWA97-10646Courtesy of AUDI OF AMERICA, LLC

-- Release the springs -arrow-, pivot the vehicle electrical system control module -4- out of the bracket -5- and remove it downward.

GWWA97-11879Courtesy of AUDI OF AMERICA, LLC