Rear Fender Cover, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• The vehicle and the cover must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution:D 009 401 04  and let dry.

-- Remove the protective film from the adhesive tape -1- and press on the rear cover -2- with the :3356  .

Courtesy of AUDI OF AMERICA, LLC

• Vehicle resting time is at least 30 minutes at room temperature.