LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Cooling System [CNTC,CYFB] (1 Of 2) [Coupe]) >> 19 Cooling System >> Radiator/Radiator Fan >> Auxiliary Radiator, Removing And Installing >> Removing

Auxiliary Radiator, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the left front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Unclip the air duct -1- in direction of -arrows-.

GWWA19-11744Courtesy of AUDI OF AMERICA, LLC
NOTE:

Place a cloth underneath to catch any leaking coolant.

GWWA19-11745Courtesy of AUDI OF AMERICA, LLC

-- Clamp off the coolant hoses -1- with the :3094  .

-- Loosen the clamps and remove the coolant hoses.

-- Free up the coolant hoses from the bracket, to do so open the retainers in direction of -A arrows- and remove in direction of -B arrows-.

-- Remove the nuts -arrows- and remove the auxiliary radiator -1- with the bracket.

GWWA19-11746Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the air duct -1- -arrow-.

GWWA19-11747Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -4- and remove the auxiliary radiator -2- from the bracket -3- upward.