Transmission Coolant Valve -N488-, Removing And Installing, Version 2: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Open the clip -2- and free up the coolant hose -1- and push to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clip upward from the air duct pipe.

-- Disconnect the connector -1-.

Fig 1: Transmission Coolant Valve -N488- Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows-.

NOTE:

Place a cloth underneath to catch any escaping coolant.

-- Clamp off the coolant hoses on the Transmission Coolant Valve -N488- with :3094 and remove, to do so loosen the hose clamps -2-.

-- Remove the coolant valve.