Coolant Shut-Off Valve -N82-, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Loosen the hose clamp -2-.

-- Remove the bolt -1- and push the left air duct pipe slightly to the left.

Version with Secondary Air System:

Fig 1: Secondary Air Injection Sensor 1 -G609- / Secondary Air Injection Solenoid Valve -N112- component location

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Press the release buttons on both sides and remove the secondary air injection hose -2-.

Continuation for All Vehicles:

Fig 2: Installed Location Coolant Shut-Off Valve -N82-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Clamp the coolant hoses on Coolant Shut-Off Valve -N82- with the :3094 .

NOTE:

Place a cloth underneath to catch any leaking coolant.

-- Loosen the hose clamps -1- and remove the coolant hoses.

-- Remove the bolts -arrows- and remove the Coolant Shut-Off Valve -N82-.