Transmission Coolant Pipe, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
WARNING:
The cooling system is under pressure when the engine is warm. There is a risk of scalding due to hot steam and hot coolant.
Scalding the skin and other parts of the body is possible.
- Wear safety gloves.
- Wear protective eyewear.
- Reduce the pressure by covering the coolant expansion tank cap with a cloth and carefully opening it.
-- Briefly open the coolant expansion tank cap -arrow- and release any residual pressure in the cooling system and then close it again until it locks.
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
-- Remove the bolt -1- and nut -2-.
-- Place a cloth underneath to catch any escaping coolant.
-- Loosen the hose clamps -arrows-, then clamp off the coolant hoses with the :3094 and remove the hoses.
-- Remove the coolant pipe.