Audi TT from MY 2017
| Vehicle | Required Adapters for the Connections to A/C Compressor | Adapters Necessary for the Connections to the Reservoir or Receiver/Dryer | Miscellaneous |
|---|---|---|---|
| Audi Q2 (GA_) from MY 2017 Audi A3 (8V_/ 85_) from MY 2017 Audi TT (FV_) from MY 2017 Audi Q3 (F3_) from MY 2019 Audi A1 (GB) from MY 2019 Audi A3 (8Y_) from MY 2021 |
|
Receiver/dryer (different versions)-- No adapter necessary, the receiver/dryer remains installed (or is integrated in the condenser).-- Depending on the condenser version, remove the dryer cartridge from the receiver/dryer on the condenser before flushing and then seal the opening again (see note). | Expansion valve remove and installed with the Refrigerant Circuits - Adapter 38 :VAS6338/38 (or a drilled open expansion valve. Refer to CLEANING THE REFRIGERANT CIRCUIT, PRELIMINARY WORK (FLUSHING WITH REFRIGERANT R1234YF) .) |
Depending on the condenser manufacturer, the receiver/dryer version is different. On some versions for example the receiver/dryer is integrated in the condenser. The integrated receiver/dryer has a dryer cartridge that is no longer available as a replacement part. Therefore, if there is a complaint regarding a vehicle with a condenser with an integrated receiver/dryer, it may be necessary to replace the entire condenser after correcting the complaint. Refer to the Parts Information and Refrigerant Circuit (vehicle-specific Service Information).
Condensers with an integrated receiver/dryer or dryer cartridge that cannot be replaced separately or is not available as a replacement part, the condenser must be replaced after flushing (with the dryer cartridge installed). Refer to Refrigerant Circuit (vehicle-specific Service Information) and the Parts Information.