Leaking Or Damaged Areas, Replacing, Full Refrigerant Circuit Except A/C Compressor And Receiver/Dryer

WARNING: This page is about a different variant/trim than selected.

Refrigerant Circuit Still Contains Refrigerant (for Example, with Minor Leak)

Pay attention to the general information for replacing components. Refer to GENERAL INFORMATION FOR REPLACING COMPONENTS .

-- Discharge the refrigerant circuit. Refer to WORKING WITH A/C SERVICE STATION .

-- Remove the malfunctioning component, flush with compressed air, collect escaping refrigerant oil.

-- The new component is to be filled with the amount of refrigerant oil flushed out (positive 20 cm³ for evaporator, positive 10 cm³ for condenser, refrigerant pipes and refrigerant hoses) as fresh refrigerant oil fill.

NOTE:

Dispose of old refrigerant oil (pay attention to local regulations).

-- Assemble, evacuate and charge the refrigerant circuit. Refer to WORKING WITH A/C SERVICE STATION .