Refrigerant Circuit Connections With Valve For Switches
WARNING: This page is about a different variant/trim than selected.
NOTE:
Switch pressures, removing and installing switches as well as switch arrangement and version. Refer to vehicle specific refrigerant circuit. Refer to Refrigerant Circuit (vehicle-specific Service Information).
- Different threads for switch on high pressure and low pressure sides.
- Only valves and O-ring seals that are resistant to refrigerant R134a and refrigerant oil must be installed.
A - Connection (soldered in)
B - O-ring seal
C - Valve (with O-ring seal)
NOTE:
To remove and install the valve insert -C- when the refrigerant circuit is discharged, use, for example, an adapter from the Refrigerant Sockets :T10364 (for the tightening specification. Refer to CONNECTIONS WITH SCHRADER VALVE (NEEDLE VALVE) ).