A/C Compressor -G111-

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying A/C Compressor Speed Sensor G111

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Switch pressures, removing and installing switches as well as switch arrangement and version. Refer to vehicle specific refrigerant circuit Refrigerant Circuit (vehicle-specific Service Information).

Inductive sensor

The sensor pulses (4 per compressor revolution) and the engine speed enable the Front A/C Display Control Head -E87- or the Climatronic Control Module -J255- to calculate belt slip.

If the belt slip exceeds a specified value, the compressor is switched off by the control module via the A/C clutch.

NOTE:

Installed in Audi vehicles with an A/C compressor driven the a ribbed belt and with Zexel compressor. Refer to Refrigerant Circuit (vehicle-specific Service Information).

Beginning from production year 2006, the name of the "Zexel" A/C compressor was changed from "Zexel" to "Valeo".