Side Bolster, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS FOR PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the : VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the backrest cover and side trim. Refer to BACKREST COVER, REMOVING AND INSTALLING, SUPER-SPORT SEAT .
-- Remove the backrest seat cover and cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING, SUPER SPORT SEAT .
-- Equipment level with Pneumatic seat: remove the backrest bolster adjuster air cushion. Refer to BACKREST BOLSTER ADJUSTER AIR CUSHION, REMOVING AND INSTALLING .
-- Remove the bolts -2 and 3-.
WARNING:
Risk of eye injury.
- Wear protective eyewear!
-- Drill out the rivets -1-.