LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Seat Frames [Coupe]) >> 72 Seat Frames >> Front Seat Pneumatic System >> Front Passenger Multi-Contour Seat Control Module -J872- /Driver Multi-Contour Seat Control Module -J873-, REMOVING AND INSTALLING >> Installing

Front Passenger Multi-Contour Seat Control Module -J872- /Driver Multi-Contour Seat Control Module -J873-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

-- After connecting the pneumatic lines and give them a push again and then a final tug to see whether the coupling is locked in correctly.

WARNING:
  • Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS FOR PYROTECHNIC COMPONENTS .
  • Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker pin, for example.
  • Observe all measures when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

Install in reverse order of removal.

scientia non olet · About LEMON Manuals