Left/Right Vent Temperature Sensor -G150- / -G151-, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

-- Replace the seal -3- if it is damaged or faulty.

NOTE:

An improperly installed vent temperature sensor or a damaged seal causes flow-generated noise.

-- Install the remaining components.

-- Check the DTC memory and erase any displayed entries, then perform the "basic setting". Use the Vehicle Diagnostic Tester in the"Guided Fault Finding" function.

-- Check the heating and A/C system function.