FOOTWELL Vent Temperature Sensor -G192-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
WARNING:
Risk of injury by the knee airbag.
- Before working in the area of pyrotechnic components, the person must "discharge static electricity". Follow the safety precautions when working on the airbag. Refer to SAFETY PRECAUTIONS FOR PYROTECHNIC COMPONENTS (Body Interior; Safety Precautions; Safety Precautions when Working on Pyrotechnic Components).
-- Turn off the ignition.
-- Versions with ignition lock: Remove the ignition key.
-- Remove the driver side instrument panel cover (or knee airbag). Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .
-- Remove the driver side footwell vent. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Release the tabs on the left and right using a small screwdriver -arrows-.
-- Remove the Footwell Vent Temperature Sensor -G192- -2- upward.
-- Disconnect the connector -1-.