Evaporator Vent Temperature Sensor -G263-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the footwell vent on the front passenger side. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Release the retaining tabs with a small screwdriver in direction of -arrows-.
-- Remove the Evaporator Vent Temperature Sensor -G263- -2- from the housing.
-- Disconnect the connector -1-.