Belt Pulley, Removing And Installing, SANDEN A/C Compressor

WARNING: This page is about a different variant/trim than selected.

NOTE:

The belt pulley is sensitive to impact. Handle it with special care.

If the belt pulley overload protection was activated, check the A/C compressor for ease of movement before replacing the belt pulley. Replace an A/C compressor that is not operating smoothly.

If the drive plate overload protection was activated, the belt pulley can be rotated using the outer part of the drive plate so that the A/C compressor shaft and the hex fitting on the drive plate (inner part of the drive plate) do not rotate.

-- Detach the right front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING [CNTC, CYFB] / RIBBED BELT, REMOVING AND INSTALLING [DAZA] .

-- Belt Pulley, Removing and Installing. Refer to OVERVIEW - BELT PULLEY, SANDEN ("Delphi/Mahle") A/C COMPRESSOR .