Instrument Panel Vent, Removing
WARNING: This page is about a different variant/trim than selected.
-- Switch off the ignition.
-- Versions with ignition lock: Remove the ignition key.
-- Turn the operating lever -2- to the "6 o'clock" position.
-- Carefully guide the hook -3- (for example, Hook Tool:T40207 ) between the slats and hook it in at the back of the vent -1-.
-- Carefully remove the vent -1- from the installation opening -arrow-.
-- If an instrument panel vent has an installed control knob -4-, release and disconnect the connector -2-.
-- Release the pin -3- and remove it -arrow-.
-- Remove the cover or display control knob -4- from the removed instrument panel vent -arrow-.