Center Instrument Panel Vent Air Ducts, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

-- If the foam seal on the air duct intermediate piece -2- is damaged or faulty, replace the air duct.

-- Replace a damaged or faulty air duct intermediate piece -2-.

-- Replace a damaged or faulty air duct -3-.

NOTE:

The foam seal on the air duct intermediate piece -2- must not be crumpled when inserting the instrument panel. This will cause the air duct to the instrument panel vents to be uneven or unsatisfactory.

After installing the instrument panel, check the direction and distribution of the airflow coming out of the instrument panel vents.

-- Make sure that the guides on the air duct are positioned correctly in the mounts.

Install the remaining components.

Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.

Check the heating and A/C system function.