Exhaust System, Installing Without Tension

WARNING: This page is about a different variant/trim than selected.

Procedure

-- Loosen the threaded connections for the front clamping sleeve -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Push the exhaust system far enough forward until the pre-load on the retaining loops at the exhaust pipe -a- = 5 mm.

Fig 1: Identifying Tail Pipe Aligning

Courtesy of AUDI OF AMERICA, LLC

-- Install the front clamping sleeve. Refer to Figure.

Tail Pipes, Aligning

Fig 2: Checking Distance Of End Pipes At Left/Right To Bumper

Courtesy of AUDI OF AMERICA, LLC

-- Align the rear muffler so that the space between the opening for the bumper and the tail pipes is the same.

Tightening Specifications