Right Flange Shaft, Removing And Installing, Vehicles With Fwd: Removing

• The transmission is installed.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- If installed, remove the bolts -arrows-, and remove the right drive axle heat shield.

Fig 1: Drive Axle Heat Shield

Courtesy of AUDI OF AMERICA, LLC

-- Turn steering as far as possible toward right.

-- Remove the drive axle from on the right of the transmission -arrow-. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- on the right ball joint.

Fig 2: Ball Joint To Lower Control Arm Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut from the bracket for the Right Front Level Control Sensor -G289-.

-- Disengage the right ball joint from the transverse link.

-- Fasten the right ball joint -2- on the transverse link -1- with the nut -arrow-, as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Tie up the right drive axle toward the rear.

• Be careful not to damage the protective coating on the drive axle.

-- Install two bolts into the flange, counterhold the flange shaft with the pry lever and remove the bolt -arrow- from the right flange shaft.

Fig 3: Installing Bolts Into Flange And Counter-Holding Flange Shaft Using A Pry Bar

Courtesy of AUDI OF AMERICA, LLC

-- Remove the flange shaft.