Seal On Bevel Box Between Transmission And Bevel Box, Replacing

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Procedure

-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .

-- Pry out the seal on the bevel box using the : T20143/1 or : T20143/2 .

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and sealing lips on the new seal with transmission fluid.

Fig 2: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts Information for the correct sealing grease.

-- Drive the new seal all the way in using the : T10298 . Do not tilt it while doing so.

Fig 3: Driving In Sealing Ring As Far As Stop Using Thrust Piece T10298

Courtesy of AUDI OF AMERICA, LLC

-- Install the bevel box. Refer to BEVEL BOX, REMOVING .