Right Seal, Replacing

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Procedure

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Remove the right seal using the : T20143/2 .

-- Coat the outer circumference and sealing lips on the new seal with transmission fluid.

Fig 1: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts Information for the correct sealing grease.

-- Drive the new seal all the way in using the : T10049 . Do not tilt it while doing so.

Fig 2: Driving In New Sealing Ring To Stop Using Thrust Piece T10049

Courtesy of AUDI OF AMERICA, LLC

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Check the gear oil level. Refer to GEAR OIL, CHECKING LEVEL .