LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Controls, Housing [Coupe]) >> 34 Controls, Housing >> Selector Mechanism >> Overview - Shift Mechanism >> Overview - Shift Mechanism, AUDI A3, Q2, Q3 And TT

Overview - Shift Mechanism, AUDI A3, Q2, Q3 And TT

WARNING: This page is about a different variant/trim than selected.
Fig 1: Shift Mechanism Exploded View
GWWA34-11156Courtesy of AUDI OF AMERICA, LLC
  1. Selector Lever Cable
    • Cannot be replaced separately
    • Do not lubricate
  2. Nut
    • 8 Nm
    • For selector mechanism to body
    • Quantity: 4
  3. Bolt
    • 4 Nm
    • For the selector mechanism to the selector housing
    • Quantity: 4
  4. Shift Mechanism
    • The following components are combined into a single component
      • Selector Lever -E313-
      • Selector Lever Sensor System Control Module -J587-
      • Selector Lever Park Position Lock Switch -F319-
      • Shift Lock Solenoid -N110-
      • Selector Lever Cable
    • The components cannot be replaced separately
    • To check the components, use the Vehicle Diagnostic Tester in Guided Fault Finding 
    • Selector Mechanism Emergency Release. Refer to EMERGENCY RELEASE FROM P .
    • Shift Mechanism, Removing and Installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
  5. Shifter Housing
  6. Base Plate
    • Replace after removing
  7. Clamps
    • Replace after removing
  8. Bolt
  9. Joint
  10. Shift Lever
  11. Nut
    • 20 Nm
  12. Lock Washer
  13. Cable Bracket
    • For the selector lever cable
  14. Bolt
    • 15 Nm
scientia non olet · About LEMON Manuals