Bevel Box, Tightening Specification
WARNING: This page is about a different variant/trim than selected.
Bevel Box to Dual Clutch Transmission
- Replace the bolts after removing them.
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -arrows- | Install all the way by hand |
| 2. | -arrows- | 40 Nm diagonally |
| 3. | -arrows- | 90° additional turn, diagonally |
Bracket for Bevel Box - Vehicles with TFSI Engine
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install all the way by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |
Bracket for Bevel Box - Vehicles with TDI Engine
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install all the way by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |