Transmission Mount, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi TT Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
-- Fasten the transmission mount -A- on the longitudinal member.
-- When re-installing the transmission mount -1-, align it according to the markings made earlier and fasten it in place -arrows-.
CAUTION:
Risk of damaging threads in transmission support by inserting bolts at an angle.
- The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing bolts -arrows-. If equipped, lift the rear of the transmission using a floor jack or the :VAS6931 .
- Remove the :10-222A only when the bolt for the subframe mount -arrows- have been tightened to the tightening specification.
-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.
-- Remove the :10-222A from the engine.
-- Install the Engine Control Module -J623-. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .