Engine Mount, Removing And Installing: Removing

-- Remove the right front wheel. Refer to WHEELS AND TIRES .

-- Detach the right front wheel housing liner from the longitudinal member. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the bolt -2- and nut -3- and move the right coolant pipe to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the fuel hose and the EVAP system hose from the coolant expansion tank at -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Engine Coolant Level Warning Switch -F66-.

-- Release the retainers with a screwdriver in direction of -arrow- and move the coolant expansion tank to the side.

-- Remove the left and right foam wedge -1- upward.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -3- and remove the air duct hose.

Courtesy of AUDI OF AMERICA, LLC

-- Position the :10-222A  on the fender bolting edges as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Attach the spindle carabiner hooks to the engine lifting eyes.

-- Pretension the engine/transmission assembly with both spindles, but do not lift it.

• If the engine mount is going to be re-installed, mark its installation position.

  Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and engine mount -1-.

TIP:

The rear bolt in the cylinder block is accessible from the wheel housing side. To do so loosen the wheel housing liner and push to the side. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .