Coolant Distribution Housing, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi TT Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front coolant pipes. Refer to FRONT COOLANT PIPES, REMOVING AND INSTALLING .
-- Remove the coolant thermostat. Refer to COOLANT THERMOSTAT, REMOVING AND INSTALLING .
-- Remove the MPI system fuel rail. Refer to FUEL RAIL, REMOVING AND INSTALLING, MPI SYSTEM .
-- Remove the oil dipstick -2-.
-- Free up the wiring harness.
-- Remove the bolt -arrow- and disconnect the oil dipstick guide tube -1- from the cylinder block.
-- Seal the opening in the cylinder block with a suitable plug from the :VAS6122 .
-- Loosen the hose clamps -1- and remove the coolant hoses.
-- Remove the bolts -arrows- and remove the coolant distribution housing -3- from the cylinder block towards the left.