Coolant Distribution Housing, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi TT Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the O-ring and seal after removing.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
-- Clean and/or smooth the sealing surfaces of the O-rings.
-- Coat the O-ring with coolant and slide it onto the coolant distribution housing.
-- Install the MPI system fuel rail. Refer to FUEL RAIL, REMOVING AND INSTALLING, MPI SYSTEM .
-- Insert the coolant distribution housing in the hole on the cylinder block.
-- Install the coolant thermostat. Refer to COOLANT THERMOSTAT, REMOVING AND INSTALLING .
-- Install the front coolant pipes. Refer to FRONT COOLANT PIPES, REMOVING AND INSTALLING .