Intermediate Shaft Speed Sensor -G265-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2018 Audi TT Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Install the intake manifold upper section. Refer to INTAKE MANIFOLD UPPER SECTION, REMOVING AND INSTALLING .
After removing or replacing the intermediate shaft speed sensor the adaptation values for the chain length must be adapted again.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drivetrain
- Select the engine code and engine
- 01- OBD-capable systems .
- 01 - Engine Electronics
- 01 - Engine electronics, functions
- 01 - Chain length diagnostic adaptation