Special Tools
WARNING: This page is about a different car, the 2018 Audi TT Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Spark Plug Removal Tool: 3122B
- Compression Tester Kit: VAG1763
- Compression Tester Kit - Adapter 5A: VAG1381/5A
- Fuel Injection Gauge Kit - Adapter VAG1381/1: VAG1381/1
- Vehicle Diagnostic Tester
Special tools and workshop equipment required
- Polydrive Bit Drive Socket: T10070 or commercially available socket XZN M12, at least 140 mm
- Crankshaft Adapter: T03003
- Locking Pins: T03006
- Locking Pin (3 pc.): T40011
- Crankshaft Locking Pin: T40069
- Camshaft Spacer: T40191
- Camshaft Lock : T40264/2A
- Exhaust side: Fitting Tool: T40376/2
- Torque Wrench 1332 Insert - Open Ring Wrench - 24mm: VAG1332/9
- Valve Keeper Tool Kit: VAS5161A with Valve Keeper Tool Kit - Guide Plate 2.5L TFSI: VAS5161A/39
- Dial Gauge - 0-10mm: VAS6079
- Engine and Gearbox Bracket VAS6095A: VAS6095A
- Engine Bung Set: VAS6122
- Hose Clip Pliers: VAS6362
- Cylinder Head Tensioning Device: VAS6419
- Electronic Torque Wrench 3-60Nm: VAS6583
- Pliers - Valve Seal: VAS6770
- Seal Installer - Drive Axle: VW195
- Dial Gauge Holder: VW387
- Press Piece - 60mm: VW415A
- Camshaft Installer Kit - Sleeve: 3241/4
- Puller - Valve Seal: 3364
- Intake side: Seal Installer - Valve Stem: 3365
- Not Illustrated:
- Key: T40297
- Camshaft Lock: T40264/2A